Cylinder Hones, Disassembly Benches, Nut Busters®, Shaft Polishers, Tube Washers, and Pump Testers
PRODUCTS
ABOUT US
HONE
ADDITIONAL TOOLING
Click on picture for more detail
 |
A chain vise can be supplied as an option to secure your tube for honing. Our standard is a 8” chain vise. |
 |
MS&D can significantly increase your honing production with the use of Borazon stones. Borazon is a General Electric synthetic diamond bonded into a metallic matrix. MSD-H-40, 60/80, 280, 400 We manufacture a set of stones that fit into Sunnen ARN master holders. Borazon outlasts aluminum oxide stone by more than 100 times. We produce sets of 40, 60-80 grit stones for heavy material removal and sets of 280 & 400 grit stones for finishing. (All stone sets are sold in sets of 4) With a 4 stone configuration you can halve your honing time and eliminate frequent stone changes. |
 |
MSD-H-V An option is to use a non-marring nylon “V” to support one end of the tube being honed. The “V” can be easily secured at any point along the length of the tube end of the hone. |
 |
MSD-H-M This fixture sets in the honing oil tank. The returning oil runs under the fixture and the magnet pulls the ferrous material out of the oil. (Simple pull of the release handle releases the ferrous material for disposal.)
|
 |
MSD-H-R (remote cable) Cable and switch for remotely jogging the honing head during set-up to accurately positioning magnetic stops. The cable is connected to a receptacle provided on the control panel to remotely activate the carriage traverse.  |
 |
MSD-H-F (head RPM /flow) A specially calibrated “Hedland” flow meter can act as a simple tachometer for rotational speed. |
 |
MSD-H-PAL After honing a cylinder bore to size, it is often difficult to reach a good finish with honing stones. Machinery Service & Design has developed a new and simple approach to this problem. We start with a set of standard “Sunnen” key way stones; remove the stone material and cover the holder face with a “Velcro” type material. This can be done for all size range. We use “3M” abrasive pads cut to size and bonded to a mating “Velcro” material. The abrasive pads will now hold firmly in place but can be easily removed and replaced. |
Stand out from your competition by having certified people working for you. Check out the Fluid Power Society Web site for information on certification for Hydraulic Specialists, Hydraulic Mechanics and Hydraulic Technicians.
Beginning and Intermediate Fluid Power Training
Fluid power courses for IFPS Certification or customized classes for your companies needs. Contact Leslie's Contract Services at sales@fi2m.net or call 414-617-4870 for information
The Equipment Service Association is an association of companies successfully engaged in the sales and service of hydraulically, pneumatically or electrically operated tools, components, and equipment.
Check them out at www.2esa.org
HydraulicRepairShops.com is the place to find hydraulic repair shops and hydraulic repair parts suppliers. Find shops that repair hydraulic cylinders, hydraulic pumps, hydraulic presses, hydraulic lifts, hydraulic motors, hydraulic power units, hydraulic systems, and other hydraulic components. Add Your Hydraulic Repair Shop to the list of companies on this site for a small fee.